Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
MP Diagnostic Test (#1406)
This test is destructive.
The MP Diagnostic Test runs the following diagnostic tests in the following order, but only if
each successive test passes:
DSP FPGA Query - This test verifies the status of the FPGA device on the TN2302 circuit pack.
If the device is bad, the system posts an error and alarm and takes out of service every DSP
that is controlled by the one FPGA. The system then attempts to reset the FPGA. If the reset
passes or the original test passes, the DSPs are placed back into service.
Ethernet Query - This test passes if the TN2302 hardware is functioning properly and the
Ethernet port is connected. Otherwise, it fails.
SCOTCH Sanity - The SCOTCH device on a board communicates with switch software via the
TDM bus for conferencing and gain adjustment by setting up connections on TDM bus time
slots. If errors are reported from the board, the system takes the DSPs out of service and
executes a circuit pack reset (SAKI Test #53)
This test runs on IPMEDPRO (TN2302 IP Media Processor).
Table 626: MP Diagnostic Test (#1406) 1 of 2
Error
Code
2012
2100
Test
Result
Description / Recommendation
ABORT System error.
System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The MP Diagnostic test failed and the circuit pack is in the
out-of-service state.
Error Codes 8192 - 8328: The FPGA DSP Test failed.
Error Codes 16384 - 16900: A SCOTCH device failed.
Error Codes 24576 - 24580: An ETHERNET device failed.
1. Reset the circuit pack with busyout board location,
reset board location, and release board location.
2. Enter test board location long.
Replace the circuit pack if the test continues to fail.
PASS The FPGA device on this circuit pack is operating correctly.
2012 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2