Server Alarms - Avaya Support

Table 506: TSC Heartbeat Inquiry Test (#604)
Error
Code
Test
Result
Description / Recommendation
TSC Heartbeat Inquiry Test (#604)
1148 ABORT The ADM TSC is enabled, but inactive at the near end.
1. Disable and enable the ADM TSC.
2. Enter test tsc-administered.
3. If the ADM TSC is still inactive, check the other nodes in the network.
1149 ABORT The ADM TSC is disabled.
1. Enable the TSC, and see if the status indicates active.
2. Enter test tsc-administered.
3. If the TSC still disabled, remove the ADM TSC from the system.
1181 ABORT Ran out of ADM TSC resources.
1. Enter test tsc-administered at 1-minute intervals up to 3 times.
2000 ABORT The Administered TSC is not responding to a TSC heartbeat inquiry.
1. Enter test tsc-administered at 1-minute intervals up to 3 times.
2. If the problem continues to fail, obtain the status of the D-channel or
D-channel pair associated with the ADM TSC using status
signaling-group grp#. If the D-channel is INS (i.e., in-service)
and the status of the ADM TSC appears to be active, then disable and
enable the ADM TSC through administration.
NOTE: To disable the ADM TSC, display the Signaling Group
administration screen using change signaling-group grp#
where grp# refers to the number of the signaling group under which
the suspect TSC is administered. Set the Enable field to n. To enable
the ADM TSC, set the Enable field to y.
3. Enter test tsc-administered.
4. If the test fails, check the ADM TSC node on the other side of the
network to verify that the ADM TSC is indeed active.
2012 ABORT Internal system error.
1. Enter test tsc-administered at 1-minute intervals up to 5 times.
3 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1747