Server Alarms - Avaya Support

Table 535: SNI-BD Configuration Audit (#759) 3 of 6
Error
Code
102 -
109,
113-
120
Test
Result
Description / Recommendation
Configuration Audit (#759)
FAIL The SNI circuit pack cannot communicate with the SNI in a different slot.
1. Determine the slot number of the other SNI: Subtract 100 from the
Error Code. For example, if the Error Code is 107, the SNI slot
number is 7. This number is referred to as the "specified SNI slot".
2. Perform the Fiber link fault isolation procedure in Maintenance
Procedures (03-300432). This will resolve multiple SNI-PEER errors.
3. See Table 530: SNI Slot / Error Type to determine the Error Type for
SNI-PEER errors. For example, if the specified SNI slot is 9, the Error
Type is 1793. If the SNI being tested has SNI-PEER errors of the
specified Error Type, replace the SNI being tested. Replacing an SNI
may be service interrupting. See SNI-BD (SNI Circuit Pack) for the
procedure for replacing an SNI. To view SNI-PEER errors, enter
display errors with category PNC-PEER. Retry the command.
4. If the SNI being tested has SNI-PEER errors of the specified Error
Type, replace the SNI in the specified SNI slot. Retry the command.
112 FAIL The SNI circuit pack cannot communicate with the active SNC.
1. Check the error log for other SNI circuit packs in the same carrier with
a 257 SNI-BD error. Enter display errors with category PNC to
view SNI-BD errors. If other SNI circuit packs in the same switch node
carrier have error 257, then replace the active SNC in this switch node
carrier. Replacing an SNC may be service interrupting. See SNC-BD
(Switch Node Clock Circuit Pack) for the procedure for replacing an
SNC. If other SNI circuit packs in the same carrier do not have
SNI-BD Error Type 257 logged, proceed to step 2.
2. Replace this SNI. Replacing an SNI may be service interrupting. See
SNI-BD (SNI Circuit Pack) for the procedure for replacing an SNI.
3. Replace the active SNC in the same switch node carrier. Replacing an
SNC may be service interrupting. See SNC-BD (Switch Node Clock
Circuit Pack) for the procedure for replacing an SNC.
133 FAIL No neighbor link is administered, but the SNI has an EI neighbor.
1. Administer the SNI on a fiber link to the EI neighbor it is connected to
using add fiber-link next. Or remove both fiber endpoints (i.e.,
this SNI and its EI neighbor) and remove the fiber endpoints from
circuit pack administration using change circuit-pack.
3 of 6
Communication Manager Release 5.0 Issue 4 January 2008 1825