Server Alarms - Avaya Support

Table 114: AN-LN-PT Error log entries 2 of 2
Error
Type
Aux
Data
257 (e) 40973 None
Associated Test Alarm
Level
AN-LN-PT (Analog Line Port)
513 (f) Ringing Application Test (#48) WRN OFF test port location r 2
769 Port Diagnostic Test (#35) MIN
WRN 1
1025 Looparound test (#161) MIN
WRN2
1281 Conference Circuit Test (#7) MIN
WRN2
1537 NPE Crosstalk Test (#6) MIN
WRN2
On/Off
Board
Recommended Action
ON test port location r 2
ON test port location l r 2
ON test port location l r 2
ON test port location l r 2
1. Minor alarms on this MO may be downgraded to Warning alarms based on the values used in set
options.
Notes:
a. Error type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: these are inline errors and can only be resolved over time.
2 of 2
● Aux Data 40960 indicates that too many simultaneous incoming ringing attempts were
made on this board. Only 4 ports on a board may ring simultaneously. A 5 th incoming call
causes an inline error from the board.
● Aux Data 40975 indicates that the terminal equipment was on-hook when ring-tip was
detected during ringing. This usually indicates a failure in the terminal equipment or the
type of terminal has a low ringer impedance.
1. Call the terminal equipment and verify that the terminal rings.
2. If the terminal does not ring, replace it. Otherwise, run test port location, and
follow the procedure for ONS Ringer Application Test (#48).
● Aux Data 40977 indicates that no terminal equipment was connected when ringing was
attempted. Run test port location, and follow the procedure for the results of ONS
Ringer Application Test (#48).
c. Error Type 15: software audit error that does not indicate any hardware malfunction. Run
the short test sequence, and investigate any associated errors.
d. Error Type 130: the circuit pack or media module has been removed or has been insane for
more than 11 minutes. To clear the error, reseat or replace the circuit pack or media module.
Communication Manager Release 5.0 Issue 4 January 2008 453