Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 386: Digital Station Audits Test (#17) 3 of 4
Error
Code
Test
Result
Description / Recommendation
5 ABORT Ringer update aborted. Data module or station not in the in-service state.
PDMODULE, TDMODULE:
1. Verify that the data module is powered (power LED on).
2. Make sure data module is connected to the building wiring, check for
faulty wiring, check for faulty data module.
3. Retry the command at 1-minute intervals up to 5 times.
4. Replace the Data Module and repeat the test.
5. If the test continues to abort, replace the Digital Line circuit pack and
repeat the test.
DIG-LINE, RDIG-STA: The port could have been busied out by a system
technician.
1. Look in the Error Log for Error Type 18 for this port. If this error is
present, release the port using release station extension.
2. Make sure that the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
6 ABORT Touch-tone update failed.
1. Retry the command at 1-minute intervals up to 5 times.
7 ABORT Downloadable parameter downlink failed.
1. Retry the command at 1-minute intervals up to 5 times.
8 ABORT Terminal levels audit failed.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using display port, where the
display shows that the port is a TTI port, or list config, where
the display shows a t for the port.
2. If list config or display port indicate that the port is not a TTI
port, escalate the problem. If both commands indicate that the port is
a TTI port, the abort is correct, and no action is necessary.
1478 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
3 of 4