Server Alarms - Avaya Support

Table 231: H323-SGR Error Log Entries 2 of 2
Error
Type
2561(m) Any Registered to LSP Inline Error MIN OFF
2817 (n) T303 Timer timed out
3585 (o) Layer 3 Test (#1673) MIN OFF
3841 -
3942 (p)
Aux
Data
Any
Associated Test Alarm
Level
On/Off
Board
H323-SGR (H.323 Signaling Group)
Recommended Action
2 of 2
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: Failure of the C-LAN hardware (IP-PROCR in S8300 systems) carrying the
signaling group channel. To determine which C-LAN had been administered for this
signaling group, find the near-end node name on the signaling group form, then find
the C-LAN or IP-PROCR with the same node name on the ip-interfaces form.
Check for errors against the CLAN-BD MO.
c. Error Type 18:The signaling group in question has been busied out by command. Release
the signaling group, if appropriate, with release signaling-group grp#.
d. Error Type 257: Tracks failures of the H.323 signaling-group PING test. See Signaling
Group Ping Test (#1387) for test failure information.
e. Error Type 513: Tracks excessive round-trip delay of the H.323 signaling-group PING test,
if the round-trip delay exceeds 4 seconds. See Signaling Group Ping Test (#1387) for test
failure information.
f. Error Type: 770: Tracks excessive latency and packet-loss from background IP
measurements collected by the Media Processor Board. Indicates that test packets sent
from a media processor circuit pack to the far-end IP address specified on the signaling
group form have exceeded the IP latency and loss thresholds, as administered on the
system-parameters ip-options form. Exceeding these thresholds indicates that the
IP network may not be providing sufficient quality of service for adequate transmission of
voice. If the signaling group has been administered to enable BYPASS, then Error Type
1025 also occurs.
g. Error Type 1025: The signaling group has been placed into a BYPASS condition because
of IP network congestion. The signaling group accepts incoming calls, but every outgoing
call is denied. The system routes these calls over a secondary route, if one has been
administered.
Communication Manager Release 5.0 Issue 4 January 2008 865