Server Alarms - Avaya Support

Table 626: MP Diagnostic Test (#1406) 2 of 2
Error
Code
Test
Result
0 NO
BOARD
Description / Recommendation
See NO BOARD for repair procedures.
DSP Port Status Query Test (#1407)
DSP Port Status Query Test (#1407)
This test queries the state of the DSP port. It runs on MEDPROPT (MEDPRO DSP PORT).
Table 627: DSP Port Status Query Test (#1407) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2 of 2
1 ABORT This port is Out of service (OOS) due to:
● A board-level problem. For example, no IP address has been
translated for this location.
● A DSP hardware problem. See DSP Port Status Query Test
(#1407) and DSP Query Test (#1382).
2 ABORT This port has been made maintenance busy.
1002 ABORT The system could not allocate time slots for the test. The system may
be under heavy traffic conditions, or it may have time slots
out-of-service due to TDM-BUS errors. A system is considered under
heavy traffic when the Call Processing Occupancy is greater than
50% or when the System Management and the Call Processing
Occupancies together exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received in the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 2013