Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 385: Digital Station Lamp Update Test (#16) 2 of 2
Error
Code
Test
Result
Description / Recommendation
3 ABORT Station may be in ready-for-service or out-of-service state.
1. Enter status station to verify the state of the station.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the station extension
or attendant number of the port.
2. Enter status station or status attendant to determine the
service state of the port. If the port is in use, wait until it is idle before
testing. Attendants are always in use (off-hook) if the handset is
plugged in and the port is not busied out.
3. If the port status is idle, retry the command at 1-minute intervals up
to 5 times.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using either display port (the port
is a TTI port) or list config (a “t” is displayed for the port).
2. If either list config or display port indicates that the port is
not a TTI port, escalate the problem. If both commands indicate that
the port is a TTI port, the abort is correct, and no action is necessary.
FAIL Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
PASS The message to light every station lamp was successfully sent to the
port.
1. Observe the station lamps being lit when running the test. If all lamps
do not light, the other Digital Line test results may indicate related
problems that do not allow the lamps to light.
2. Investigate troubles by using other Digital Line port tests, and by
examining the station, wiring, and connections.
1474 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers