Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on SIP-SGRP (SIP Signaling Group).
Table 661: IP Signaling Group Far-End Status Test (#1675)
Error
Code
Test
Result
Description / Recommendation
ABORT Either the maintenance object is not a SIP signaling group, the signaling
group does not exist, or the signaling group type is not SIP signaling.
1005 ABORT The IP Signaling Group Far-End Status Test (Layer 3) is not enabled for
this SIP signaling group.
1008 ABORT Signaling group is not in the correct state to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1019 ABORT An IP Signaling Group Far-End Status Test is already in progress for this
signaling group.
1133 ABORT System is in restart.
1. Retry the command after the system finishes the restart.
1183 ABORT The SIP signaling group is out of service.
1. Retry the command at 1-minute intervals up to 5 times.
2000 FAIL Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The IP signaling far-end status test failed. The response was not
received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The IP signaling far-end status test passed.
2070 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers