Server Alarms - Avaya Support

Table 594: ATM Board Framer Looparound Test (#1260) 2 of 5
Error
Code
Test
Result
Description / Recommendation
ATM Board Framer Looparound Test (#1260)
1015 ABORT The ATM-EI or ATM-TRK circuit pack has not been busied out.
1. Busyout the ATM circuit pack, then rerun the test.
1031 ABORT If the ATM Expansion Interface circuit pack is in a PN and is on the active
PNC, this test cannot be executed.
1. If PNC Duplication is enabled, attempt to make the standby PNC
active using reset pnc interchange.
2. If the PNC Interchange is successful, rerun the test.
1033 ABORT Circuit pack not found.
ATM-EI:
1. Enter list atm pnc to verify the switch recognizes the circuit pack.
2. Retry the command.
ATM-TRK:
1. Enter status trunk-group to verify the switch recognizes the
circuit pack.
2. Retry the command.
1139 ABORT Major Alarm on the PN’s packet bus.
1. Resolve any PKT-BUS (Packet Bus) problems.
2. Retry the command.
1141 ABORT The Packet Interface circuit pack is out of service.
1. Resolve any PKT-INT (Packet Interface) problems.
2. Retry the command.
1144 ABRT The PPN’s packet bus has a major alarm against it. This test needs to
use the alarmed PPN’s packet bus.
1. Resolve any PKT-BUS problems.
2. Retry the command.
2 of 5
Communication Manager Release 5.0 Issue 4 January 2008 1961