Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 557: Active-Standby Peer Link Test (#888) 3 of 3
Error
Code
Test
Result
NO
BOARD
Description / Recommendation
The IPSI circuit pack’s Packet Interface module is assigned but is not
detected as physically present.
1. If the IPSI circuit pack is present, replace it.
2. If not, insert a TN2312AP IPSI circuit pack in the assigned slot, and
rerun the test.
Packet Interface Reset Test (#889)
The reset action initializes the Packet Interface firmware on the IPSI circuit pack and runs a
comprehensive set of diagnostic tests.
The demand reset action aborts if the specified IPSI circuit pack’s Packet Interface module is in
the active in-service state.
An IPSI circuit pack’s Packet Interface module is put in the out-of-service state automatically if it
resets 3 times by background maintenance within the last 15 minutes, independent of the
results of the reset action.
If the Packet Interface module is on the standby IPSI (S8700-series Fiber-PNC: and this is a highor
critical-reliability system), the demand reset action runs, independent of the service state.
This test runs on PKT-INT (Packet Interface).
Table 558: Packet Interface Reset Test (#889) 1 of 3
Error
Code
Test
Result
Description / Recommendation
1888 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
3 of 3
1334 ABORT The Packet Interface modules’s command queue is full. This should be
a temporary condition caused by a high rate of commands being sent to
a Packet Interface module. Continued operation with a full command
queue causes a system WARM restart that could escalate to more
severe restart levels.
1. Retry the command at 10 second intervals up to 5 times.
1 of 3