Server Alarms - Avaya Support

Red Alarm Inquiry Test (#140)
Since PLB is a condition rendering all DS0 channels unavailable for signaling or bearer traffic,
the system treats this the same as a Blue Alarm.
Table 433: Blue Alarm Inquiry Test (#139)
Error
Code
Test Description/ Recommendation
Result
ABORT Internal system error
1. Retry the command at 1-minute intervals for a maximum of 5 times.
2000 ABORT Response to the test was not received within the allowed time. This may
be due to hyperactivity.
1. Enter display errors on the SAT.
2. Check for Error Type 1538 for this DS1 board. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals for a maximum of 5 times.
FAIL The remote DS1 endpoint is out-of-service.
1 FAIL A Line Loopback Alarm (LLB) was detected.
2 FAIL A Payload Loopback Alarm (PLB) was detected.
1. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
PASS
2. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
Remote DS1 endpoint is in-service. Neither a Blue alarm nor a Line
Loopback alarm nor a Payload Loopback Alarm was detected.
0 NO
BOARD
See NO BOARD for the repair procedures.
Red Alarm Inquiry Test (#140)
A DS1/UDS1 Interface circuit pack or DS1 Interface Media Module raises a Red alarm when the
framing pattern of the incoming DS1 bit stream has been lost. The Red Alarm Inquiry test
checks the framing status of a DS1 board.
Communication Manager Release 5.0 Issue 4 January 2008 1603