Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 609: RC NPE Allocation Test (#1336) 2 of 2
Error
Code
Test
Result
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
ANY NO
BOARD
Description / Recommendation
RC Tone Loopback Test (#1343)
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be changed
only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the RC
is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
PASS The RC board is functioning normally.
This test is very disruptive.
The RC board must first be busied out in order for this test to run.
This tests validates the RC board circuitry by looping a 1004 Hz reflective tone to the far-end of
the RC circuit pack, then back to the processor. The Loopback Test is performed 24 times, once
for each NPE port.
This test aborts if any of the 24 tone loopback tests abort. This test fails if any of the 24 tone
loopback tests fail. If all 24 tone loopback tests pass, this test passes.
1990 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 2