Server Alarms - Avaya Support

Non-control Channel Test (#297)
Non-control Channel Test (#297)
The Non-control Channel Test is executed on the non-control channel bus. The Tone-Clock
circuit puts a tone on the non-control channel bus and the Tone Detector circuit listens to it. The
test passes if the tone is successfully transmitted on the non-control channel bus.
This test runs on TDM-BUS (TDM Bus).
Table 481: Non-control Channel Test (#297)
Error
Code
None
1001
2100
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
1005 ABORT This test is valid only on the non-control channel bus. It aborts when run on
the control channel bus. This is a valid response. Enter
status port-network to verify which bus is the control channel bus.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 3 times.
FAIL Communication on the Non-control Channel is not reliable.
1. Run the command again.
2. If the problem persists, test the active Tone-Clock circuit and Tone
Detector circuit/circuit pack in the port network where the faulted TDM
bus resides, to verify they are healthy. See the following to resolve
errors:
TONE-PT (Tone Generator)
GPTD-PT (General-Purpose Tone Detector Port)
DTMR-PT (Dual-Tone Multifrequency Receiver Port).
3. Run the command again.
4. If the problems persists, see TDM-Bus Fault Detection and Isolation.
PASS The non-control channel bus is operational.
Communication Manager Release 5.0 Issue 4 January 2008 1699