Server Alarms - Avaya Support

Table 536: Processor Route Audit Test (#760) 1 of 2
Error
Code
Test
Result
Description / Recommendation
Processor Route Audit Test (#760)
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The software timer could not be set before sending the downlink
message necessary to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2306 ABORT None of the circuit packs in this switch node carrier are responding to the
processor route messages.
1. Run test led switch-node for the switch node where this switch
node carrier resides to verify whether the LEDs on any of the boards
light.
2. If none of the LEDs light for the boards in this carrier, fix any
problems associated with the connectivity of this carrier to the server.
a. Enter list fiber-link to see the fiber connections to this
carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for any
EXP-INTF error entries associated with an IPSI connected PN.
d. Also, follow the repair procedures if there are errors for any of the
following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1829