Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
LANBIC Receive Parity Error Counter Test (#595)
This test reads and clears the LANBIC Receive Parity Error Counter on the circuit pack. This
counter is incremented by the circuit pack when it detects a parity error in data received from the
packet bus.
These errors may indicate a circuit pack problem, packet bus problem, or a problem with
another circuit pack on the bus. This test is useful for verifying the repair of the problem.
This test runs on the following maintenance objects:
● BRI-BD (ISDN-BRI Line Circuit Pack)
● CLAN-BD (Control LAN Circuit Pack)
● MG-BRI (BRI Trunk Media Module)
● TBRI-BD (ISDN Trunk-Side BRI Circuit Pack)
● VAL-BD (Voice Announcements over LAN Circuit Pack)
Table 500: LANBIC Receive Parity Error Counter Test (#595) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2000 ABORT Response to the test was not received within the allowed time.
1. If the test aborts repeatedly up to five times, reset the circuit pack
and rerun the test.
2. If the test aborts again with Error Code 2000, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
2100 Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
2500 Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
1736 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2