Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
the signal and noise levels of the conferenced output and reports whether or not these fall within
a specified acceptable range.
This test is run on HYB-LINE (Hybrid Line) and MET-LINE (MET Line).
Table 402: Hybrid Circuit and Conference Circuit Test (#57) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the station extension
of the port.
2. Enter status station to determine the service state of the port. If
the port is in use, wait until the port is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT System resources required to run this test were not available.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1522 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 3