Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 432: Loss of Signal Alarm Inquiry Test (#138) 4 of 7
Error
Code
Test
Result
Description / Recommendation
1303 FAIL The suffix of the DS1/UDS1 circuit pack is incorrect for CSU module/T1
sync splitter administration. The Near-End CSU Type field on the
add ds1 screen has been administered as integrated but the DS1/
UDS1 circuit pack does not support this.
1. If the CSU module/T1 sync splitter is to be used, and the Near-End
CSU Type field is set to integrated to allow for CSU module/T1 sync
splitter administration, remove the circuit pack and replace it with a
board that has the correct suffix. Otherwise, use change ds1 to set
the Near-End CSU Type field to other.
The suffix DS1/UDS1 circuit pack is incorrect for E1 Sync Splitter
administration. The E1 Sync-Splitter? field on the add ds1 screen has
been administered as y but the DS1/UDS1 circuit pack does not support
this.
1. If the E1 Sync Splitter is to be used, and the E1 Sync-Splitter field is
set to y to allow for E1SS administration, remove the circuit pack and
replace it with a board what has the correct suffix. Otherwise, use
change ds1 to set the E1 Sync-Splitter field to n.
1310 FAIL The Board Loopback (BLB) Test (#1209) failed.
1. Enter test ds1-loop location ds1/csu-loopback-tests
2. If the BLB test continues to fail, replace the DS1/UDS1-BD circuit
pack.
3. Run this test again.
1598 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
4 of 7