Server Alarms - Avaya Support

Table 391: Tone Generator Update/Audit Test (#41)
Error
Code
Test
Result
Description / Recommendation
Tone Detection Verification Test (#42)
Tone Detection Verification Test (#42)
ABORT The system was not able to allocate all the resources needed for this test.
1. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL The system requires a TN780, TN2182, or TN2312 Tone-Clock circuit
pack to support the administered tone-generation parameters.
1. Check the administration on the tone-generation screen.
Specifically, check the Base Tone Generation Set on page 1 and any
custom tone administration beginning on page 2.
2. Replace any existing IPSI with a TN2312, or an existing Tone-Clock
circuits packs with a TN780 or TN2182.
PASS The tone generation facility has been successfully refreshed with its
time-slot translation, and system administration is consistent with this
type of Tone-Clock.
1. Display the Error Log using display errors to make sure this
circuit pack did not generate new errors.
The test checks the operation of the circuit pack in touch-tone receiver, call classifier, and MFC
modes. It verifies the circuit pack’s ability to detect DTMF, ring back, busy reorder, and modem
answer tones, and to generate and detect forward and backward MFC tones.
This test runs on the following maintenance objects:
● CLSFY-PT (Call Classifier Port)
● DTMR-PT (Dual-Tone Multifrequency Receiver Port)
● ETR-PT (Enhanced Tone Receiver Port)
● GPTD-PT (General-Purpose Tone Detector Port)
● TONE-BD (Tone-Clock Circuit Pack)
Communication Manager Release 5.0 Issue 4 January 2008 1497