Server Alarms - Avaya Support

DID-TRK (Direct Inward Dial Trunk)
3. Refer problem to CO.
c. Error Type 1, Aux Data 57476: Rotary dial before wink occurs when the CO starts dialing
before the PBX sends wink on a wink-start trunk.
1. Verify trunk administered wink/immediate-start parameter.
2. Refer problem to CO.
d. Error Type 1, Aux Data 57477: Rotary dial too early occurs when the CO starts dialing too
soon after seizure on an immediate-start trunk.
1. Verify trunk administered wink/immediate-start parameter.
2. Refer problem to CO.
e. Error Type 1, Aux Data 57483: Rotary dial pulse during wink occurs when the CO sends
rotary dial digits too soon after seizure on a wink-start trunk.
1. Verify trunk administered wink/immediate-start parameter.
2. Refer problem to CO.
f. Error Type 15: software audit error that does not indicate a hardware malfunction. Run
short test sequence, and investigate any associated errors.
g. Error Type 130: the circuit pack or media module has been removed or has been insane for
more than 11 minutes. To clear the error, reinsert or replace the circuit pack or media
module.
h. Error Type 257, Aux Data 57472: Rotary dial pulse on-hook longer than 105 msec, the
break between rotary pulses is too long.
1. Test trunk by performing an incoming test call.
2. Refer problem to CO.
i. Error Type 257, Aux Data 57473: Rotary dial rate below 8 pulses/sec, more than 135 msec
between two successive breaks.
1. Verify trunk administered interdigit-timing parameters.
2. Refer problem to CO.
j. Error Type 257, Aux Data 57474: Rotary dial rate above 12 pulses/sec, less than 75 msec
between two successive breaks.
1. Verify trunk administered interdigit-timing parameters.
2. Refer problem to CO.
k. Error Type 257, Aux Data 57475: Digit detection, CO is starting new rotary dial digit within
150 msec of previous digit.
1. Verify trunk administered interdigit timing parameters.
2. Refer problem to CO.
Communication Manager Release 5.0 Issue 4 January 2008 685