Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on ANN-BD (Announcement circuit pack).
Table 461: Clock Match Inquiry Test (#212) 1 of 2
Error
Code
Test
Result
Description/ Recommendation
2000 ABORT Response to the test request was not received within the time allowed.
1. Enter display errors. If Error Type 1538 is present in the Error
Log for this board, reset the circuit pack.
2. Retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the test at 1-minute intervals up to 5 times.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The test failed. Announcements recorded or played back while the clock
circuitry is not functioning properly sound distorted. The ANN-BD may
be defective or the Active Tone-Clock circuit pack (TONE-BD) may be
marginal and is causing this test to fail.
1. Reset the circuit pack with reset board location, then run
this test again.
2. If the test continues to fail, proceed to Step 3 or 4 as applicable.
WARNING: Replacing
WARNING: Replacing
! WARNING:
the circuit pack results in loss of integrated
announcements. See General notes.
3. Replace the ANN-BD. Rerun the test. If the test continues to fail,
replace the Tone-Clock circuit pack.
! WARNING:
the TONE-BD causes a COLD 2 reset. See
Replacing the IPSI or Tone-Clock Circuit Pack. Replacing
the ANN-BD results in loss of integrated announcements.
See General notes.
4. If there are recurring alarms on this circuit pack caused by this test
failing, replace the ANN-BD even if the previous steps were
successful.
1652 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2