Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 512: Electronic Power Feed Inquiry Test (#622) 2 of 2
Error
Code
2000 ABORT Response to the test was not received within the allowed time.
1. If the test aborts repeatedly up to five times, reset the circuit pack
and rerun the test.
2. If the test aborts again, replace the circuit pack.
2012
2100
Test
Result
Description / Recommendation
CRC Error Counter Test (#623)
Internal system error.
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1 FAIL The BRI-LINE circuit pack reports that it has detected an overcurrent
condition and has turned off the EPF.
1. As necessary, check and repair the wiring between the circuit pack
and the endpoint or adjunct. Check the endpoints and replace one or
both sets if the sets are drawing too much current. Enter test port
location and review the results of the EPF Inquiry test to verify the
repair. If this test is still failing, proceed to step 2.
2. Enter test port location, and review the results of the Level 1
Status Inquiry test. If this test is also failing, then follow the repair
procedure for the Level 1 Status Inquiry test. Otherwise, escalate this
problem to the next tier.
PASS The Electronic Power Feed Inquiry test reports that the EPF is on.
This test reads the port’s CRC error counters that are maintained on the circuit pack. The Cyclic
Redundancy Check (CRC) is a means of error detection to determine the integrity of data frame
contents. The CRC error counter is incremented by the circuit pack when it detects a CRC error.
The test passes if the value of the counter is 0, meaning the error is cleared. If the counter is
non-zero, the test fails and the value of the counter is displayed in the Error Code field.
This test runs on ASAI-PT (ASAI Port), BRI-PORT (ISDN-BRI Port), and TBRI-PT (ISDN
Trunk-Side BRI Port).
1760 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 2