Server Alarms - Avaya Support

This test is run on RC-BD (Radio Controller Board).
Table 610: RC Tone Loopback Test (#1343) 1 of 2
Error
Code
Test
Result
Description / Recommendation
RC Tone Loopback Test (#1343)
0 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1010 ABORT An attempt was made to busy out a circuit pack that was already
busied out. This error can be ignored.
1011 ABORT An attempt was made to release a circuit pack that was not busied out.
This error can be ignored.
1026 ABORT The TDM Bus cannot be busied out because the control channel or
the system tones are present.
1362 ABORT The RC circuit pack has not been busied out.
1. Enter busyout board loc
2. Retry the test. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1-63 FAIL One or more of the 24 tone loopback tests failed.
1. Replace the RC circuit pack.
3001
3002
3003
3004
3005
3006
FAIL One or more of the 24 tone loopback tests failed.
1. Replace the RC circuit pack.
4001 FAIL The tone loopback tests that use DSPs 1 - 3 failed.
1. Replace the RC circuit pack.
4002 FAIL The tone loopback tests that use DSPs 4 - 6 failed.
1. Replace the RC circuit pack.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1991