Server Alarms - Avaya Support

Table 408: Tie Trunk Seizure Test (#73) 3 of 3
Error
Code
Test
Result
Tie Trunk EPF Test (#74)
Tie Trunk EPF Test (#74)
1040 ABORT This test is not performed for trunk ports administered as access
endpoints.
1. Verify this port is an access endpoint by using display port.
2. If the port has been administered as an access endpoint, then
this test should abort and no action is necessary.
2000 ABORT
or FAIL
Seizure message is not received back within 10 seconds.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to fail, check the far-end to ensure a
translation match at both ends.
3. Check the facility.
2100 ABORT Could not allocate the necessary system resources to run the test.
This could be due to a failure to seize the port.
1. Retry the command at 1-minute intervals up to 5 times.
0 NO
BOARD
Description / Recommendation
PASS The seizure test passes. This port is functioning properly.
1. If users are reporting troubles, examine loop connections to the
port, wiring, and stations.
See NO BOARD for the repair procedures.
3 of 3
The first part of this test checks for proper activation and deactivation of the port’s E lead. The
second part checks the M lead electronic power feed current flow.
Communication Manager Release 5.0 Issue 4 January 2008 1535