Server Alarms - Avaya Support

Table 498: Expansion Interface Packet Interface Test (#589) 2 of 5
Error
Code
1033
(cont’d)
Test
Result
ABORT
(cont’d)
Description / Recommendation
Expansion Interface Packet Interface Test (#589)
Center Stage:
If the EI circuit pack under test resides in the PN:
None of the EI circuit packs located in the PNs (on the same PNC side)
are in service (for PN EIs see the next case).
5. Enter list fiber-linklist fiber-link to determine whether
any of the PN’s EI circuit packs are administered as endpoints of a
fiber link. If not, then ignore the results of this test.
6. Enter list conf for the cabinets and carriers where the EI circuit
packs reside in every other PN. If the results returned indicated that
the circuit packs are not recognized by software, they are out of
service for this reason.
7. Enter display errors, and resolve any EXP-PN (Expansion Port
Network)errors. Re-run this test.
8. If the test continues to abort with this error code, reseat the EI circuit
packs (or DS1 converter circuit pack if so equipped) on the PNs. This
will not be destructive since the circuit pack cannot be serving as the
Expansion Archangel if it is not in service.
9. Run Test #237 on each of the PN EI circuit packs, and check for
EXP-INTF circuit pack Error Type 1281 in the error log. If Error Type
is present and/or Test #237 does not pass, see repair procedures for
Expansion Interface Neighbor Query Test (#237).
10. Repeat this test.
If the EI circuit pack under test resides in the PN:
The EI circuit located in the PN is out of service.
1. Run Test #237 on each of the PN EI circuit packs and check for
EXP-INTF circuit pack Error Type 1281 in the error log. If Error Type
is present and/or Test #237 does not pass, see repair procedures for
Expansion Interface Neighbor Query Test (#237).
2. Repeat this test.
2 of 5
Communication Manager Release 5.0 Issue 4 January 2008 1731