Server Alarms - Avaya Support

Table 445: Analog Looparound Test (#161) 3 of 4
Error
Code
Test
Result
Description / Recommendation
Analog Looparound Test (#161)
1004 ABORT A valid call seized the port during the test and aborted the test.
1. Enter display port location to determine the station
extension.
2. Enter status station extension to determine the service state
of the port.
3. If the port is active, wait until it is idle before testing. Retry the
command at 1-minute intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
1005 ABORT The test is not applicable for this type of port. This error can be ignored.
1018 ABORT The test has been disabled by administration. Determine why the Test
field on the change station screen has been set to n for this station. It
may be due to the brief ringing disturbance that Ringing Application Test
48 may cause.
1. To enable the test for the particular analog station, enter
change station extension and enter y in the Test field.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
3 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1623