Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
The test passes only if both the signaling link is connected and the test frame is successfully
transmitted.
A failure may indicate a problem with:
● this circuit pack
● the packet bus
● the Packet Interface circuit pack
Table 505: Link Status Test (#601) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1125 ABORT RSCL link or circuit pack not in service.
1. Release the circuit pack with release board location.
2. Repeat the test.
3. Escalate if the problem persists.
2012 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Internal system error.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
2 FAIL The RSCL control link is disconnected.
1. Retry command at 1-minute intervals up to 5 times.
2. If the test continues to fail, run the Packet Interface test (#598) with
test board location to determine if the problem is due to the
circuit pack.
3. If the Packet Interface test (#598) fails, see Packet Interface Test
(#598) for repair procedures.
4. If the Packet Interface test (#598) passes, refer to PKT-BUS
(Packet Bus) repair procedures.
3 FAIL Received no response to RSCL control link test frame.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, reset the circuit pack with
reset board location.
3. If test continues to fail, replace the circuit pack.
1744 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2