Server Alarms - Avaya Support

Table 590: ATM Board Reset (#1256) 2 of 2
Error
Code
ATM Board Reset (#1256)
1407 ABORT This test cannot be run on an ATM-EI board that is on the active PNC
because it cannot be busied out. This error code indicates that PNC
duplication is enabled.
1. Attempt to perform a PNC interchange with
reset pnc interchange
2. If the PNC interchange is successful, busyout the original
ATM-Expansion Interface circuit pack with busyout board
location (address of the original ATM-EI board)
3. Retry the command.
2000 ABORT Did not receive the response in the allowed time.
1. Verify that the board is seen by the system with list config all.
2. If the board is visible, run the test again. If the same abort code recurs,
escalate the problem.
3. If the board is not visible to the system with list config all,
reseat the board.
4. If the board is still not recognized by the system, replace the board.
2100
2500
1
2
Test
Result
ABORT Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The circuit pack failed to reset.
The circuit pack failed to restart.
1. Run the command again.
2. If the problem persists, replace the circuit pack.
PASS The ATM circuit pack was successfully reset.
ATM-EI:
1. If status port-network still indicates that this link is down, it is
possible that one or both of the ATM-EI circuit packs are busied out.
Review the error logs and take appropriate diagnostic action for
ATM-EI (Expansion Interface Circuit Pack)
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1955