Server Alarms - Avaya Support

Table 453: Digital Looparound Test (#171) 2 of 4
Error
Code
Test
Result
Description / Recommendation
Digital Looparound Test (#171)
1180 ABORT There is no Maintenance/Test circuit pack digital port available for testing.
1. Check if the Maintenance/Test digital ports are present. Enter
list config. Ports 02 and 03 should be displayed.
2. If the digital ports 02 and 03 on the Maintenance/ Test circuit pack are
not present, see M/T-BD (Maintenance/Test Circuit Pack).
3. If the digital ports are present, retry the command at 1-minute
intervals up to 5 times.
1181 ABORT No time-slots available to connect digital ports for the test.
1. Retry the command at 1-minute intervals up to 5 times.
1182 ABORT Internal system error. Failed to connect the digital ports with time-slots.
1. Retry the command at 1-minute intervals up to 5 times.
1340 ABORT No Maintenance/Test digital port is currently available to perform this test.
1. Enter list config to determine whether the Maintenance/Test
digital ports (ports 02 and 03 on the Maintenance/Test circuit pack)
are present in the system. At least one Maintenance/Test circuit pack
must be present in PN 1 of the system. There should be at least two
such ports present. If the ports are present, proceed to step 2.
Otherwise, determine why no ports appear in the list config
display. Refer to M/T-DIG (Maintenance/Test Digital Port) and M/T-BD
(Maintenance/Test Circuit Pack).
2. Look for M/T-DIG errors in the Error Log. If present, see M/T-DIG
(Maintenance/Test Digital Port).
3. If the ports are present and no errors are logged against them, retry
the command at 1-minute intervals up to 5 times.
4. If the test continues to abort, replace the Maintenance/Test circuit
pack.
1392 ABORT This port is a TTI port. The test does not run on TTI ports.
1. Verify that the port is a TTI port using either display port (the
display shows that the port is a TTI port) or list config (a “t” is
displayed for the port).
2. If either list config or display port indicates that the port is
not a TTI port, escalate the problem. If both commands indicate that
the port is a TTI port, no action is necessary.
2 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1633