Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 532: SNI Destructive Facility On-board Test (#757) 2 of 3
Error
Code
2100
2300
2301
2304
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
The downlink message necessary to run this test could not be sent.
The timer could not be set before sending the downlink message.
SNI circuit pack is not able to run the test requested by software.
1. Retry the command at 1-minute intervals up to 3 times.
2306 ABORT The SNI circuit pack is not responding to test requests sent by software.
1. Run test led switch-node for the switch node where the SNI
board(s) reside to verify whether their LEDs light.
2. If LEDs light on the other boards in the same carrier but not on this
board, enter test board location long to run Test #760 for
the active SNC in this carrier. Wait 5 minutes, and try step 1 again. If
the board’s LEDs still do not light, replace the board. Replacing an
SNI may be service interrupting. Refer to SNI-BD (SNI Circuit Pack)
for the procedure to replace an SNI.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this
carrier to the server.
a. Check list fiber-link to see the fiber connections to this
carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for
any EXP-INTF error entries associated with the controlling IPSI
connected PN.
d. Follow the repair procedures if there are errors for any of the
following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
e. For SNI-BD, see Switch Node Interface Manual Loopback
Procedure to determine whether the circuit pack or the fiber
connection is faulty.
1806 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 3