Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 529: SNI Circuit Path Test (#755) 2 of 4
Error
Code
Test
Result
Description / Recommendation
2306 ABORT The SNI circuit pack is not responding to test requests sent by software.
1. Run test led switch-node for the switch node where the SNI
resides to verify whether the LEDs on the board turn on.
2. If the LEDs on the other boards in the carrier light, but the LEDs on
this board do not light, run Test #760 with test board location l
for the active SNC in this carrier. Wait 5 minutes, then try step 1 one
more time. If the LEDs on this board still do not light, replace this
board. Replacing an SNI may be service interrupting. See SNI-BD
(SNI Circuit Pack) for the procedure for replacing an SNI.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this carrier
to the server.
a. Enter list fiber-link to check the fiber connections to this
carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for any
EXP-INTF (Expansion Interface Circuit Pack) error entries
associated with the controlling IPSI connected PN.
d. Follow the repair procedures if there are errors for any of the
following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
4. Follow the Switch Node Interface Manual Loopback Procedure to
determine whether the circuit pack or the fiber connection is faulty.
1798 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 4