Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Aux data error codes and recommended repair procedures
Table 120: Aux data error codes and recommended repair procedures 1 of 2
Aux data Description/ Recommendation
32001 Internal system error.
1. Check other ANNOUNCE errors and take corrective action.
2. If there are no ANNOUNCE errors, retry the command at 2-minute intervals a
maximum of 3 times.
3. If restore announcements fails, escalate the problem.
32002 Announcement circuit pack is in use.
1. Retry the command at 2-minute intervals a maximum of three times.
2. If restore announcements fails, escalate the problem.
32003 Announcement port is in use.
1. Wait for all Announcement ports to become available.
2. Enter save/restore announcements.
32004 There are no announcements recorded on the Announcement Circuit Pack. Save
announcements does not prevent the destroying of the announcement file on
tape [286 systems] or on the memory card [386 systems].
32005 Integrated announcement circuit pack is not present. The Announcement Circuit
Pack is not inserted, or it is defective.
1. Enter list config to check for the presence of the circuit pack in the
system.
2. If the Announcement Circuit Pack is present, use test board location
to check the status of the Announcement Circuit Pack.
32006 Announcement Data Module not available.
1. Enter status to check the status of the Announcement Data Module.
32007 Announcement Data Module out of service.
1. Enter status to check the status of the Announcement Data Module.
32008 Announcement data is being saved or loaded.
1. Retry the command at 2-minute intervals a maximum of three times.
2. If save/restore announcements fails, escalate the problem.
478 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2