Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
● XXX-BD (Common Port Circuit Pack/Media Module).
Table 398: Ringing Application Test (#51) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error. Could not allocate the necessary system resources
to run test. The circuit pack is not installed.
1000 ABORT System resources required to run test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.d.
1. Enter display port location to determine the station extension.
Enter status station to determine the service state of the port. If
the service state indicates that the port is in use, wait until the port is
idle before retesting.
2. Retry the command at 1-minute intervals up to 5 times.
1008 ABORT Could not allocate a ringing circuit for one of the following reasons: all the
ringing circuits are in use; the ringing generator is defective; ringing
generator is not wired correctly.
1. If the test continues to abort, look for RING-GEN errors in the Error
Log.
a. If there are RING-GEN errors, see RING-GEN (Analog Ring
Generator) and try to resolve any problem(s). Then retry the test at
1-minute intervals up to 5 times.
b. If there are no RING-GEN errors, and the test continues to abort,
enter test board location on other TN742, TN769, or TN746
Analog circuit packs. If an ABORT with Error Code 1008 occurs for
this test on other circuit packs as well, then the ringing generator
may be defective or may not be wired properly. See RING-GEN
(Analog Ring Generator) maintenance documentation for details. If
an ABORT with Error Code 1008 does NOT occur on the other
ports, then all four ring generators are in use. No further action is
necessary.
2. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
1514 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2