Server Alarms - Avaya Support

Table 533: FIBER-LK Configuration Audit (#759) 2 of 9
Error
Code
Test
Result
Description / Recommendation
Configuration Audit (#759)
2306 ABORT An SNI circuit pack on the fiber link is not responding to test requests.
1. Run test led switch-node for the switch node(s) where the
SNI(s) reside to verify whether the LEDs on the board(s) light. Follow
the steps below for the SNI(s) that had no LEDs light.
2. If the LEDs on the other boards in the carrier light but the LEDs on this
board do not light, run Test #760 using test board location
long for the active SNC in this carrier. Wait 5 minutes, then try step 1
one more time. If the LEDs on this board still do not light, replace the
board. Replacing an SNI may be service interrupting. Refer to SNI-BD
(SNI Circuit Pack) for the procedure to replace an SNI.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this carrier
to the server.
4. Enter list fiber-link to determine the fiber connections to this
carrier. Check the LEDs on every SNI and EI, and fix any fiber
problems.
5. Enter display errors, and follow the repair procedures for any
EXP-INTF (Expansion Interface Circuit Pack) error entries associated
with the PN. Also, resolve errors for any of the following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2 of 9
Communication Manager Release 5.0 Issue 4 January 2008 1811