Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Session Status Test (#1286)
This test queries the status of every Ethernet or PPP port session. It runs on ETH-PT (Control
LAN Ethernet) and PPP-PT (Control LAN Packet/Port).
If the system indicates that... Then the test...
Every port session is up (ALL UP) Raises no alarm, or retires alarm
Some port sessions are up (SOME UP) Raises a WARNING alarm
Every port session is down (ALL DOWN) Raises a MINOR alarm
Table 602: Session Status Test (#1286) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1124 ABORT Ethernet or PPP link is not enabled.
1. Verify that the Ethernet or PPP link is enabled using status port
location, status link n, or display data-module.
2. If the link is not enabled, enable the link using
change data-module.
3. Repeat the test.
4. Escalate if the problem persists.
1125 ABORT Ethernet or PPP link not in service.
1. Verify whether the Ethernet or PPP link is in service with
status port location or status link n.
2. If the Ethernet or PPP link is not in service, release the link with
release link n or release port location.
3. Repeat the test.
4. Escalate if the problem persists.
2000 ABORT Response to the test was not received within the allowed time.
1. If the problem persists, reset the circuit pack and rerun the test.
2. If the problem persists, replace the circuit pack.
1976 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2