Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
● UDS1-BD (UDS1 Interface Circuit Pack)
Table 436: Major Alarm Inquiry Test (#142)
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time. This may
be due to hyperactivity.
1. Enter display errors
2. Check for Error Type 1538 for this DS1 board. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The DS1/UDS1 Interface circuit pack or media module detects a Major
alarm. The DS1 bit error rate is greater than 1/1000. The performance
of the DS1 link between the DS1 board and the remote DS1 endpoint is
very poor.
1. Enter list measurement ds1-log location to read the error
seconds measurement.
2. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
0 NO
BOARD
3. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
PASS No Major alarm is detected in DS1 board.
See NO BOARD for the repair procedures.
1608 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers