Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
When an ISDN-BRI port is placed in the out-of-service state, Level 1 is also put into the
Deactivated state. This could be due either to the system detecting a fault with the port or a
busyout port location request.
This test runs on ASAI-PT (ASAI Port) and BRI-PORT (ISDN-BRI Port).
Table 511: Level 1 Status Inquiry Test (#621) 1 of 4
Error
Code
Test
Result
Description / Recommendation
1187 ABORT The board, port, or station may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (port busied out) for this port
and ASAI-BD or BRI-BD (board busied out).
2. If this Error Type is present for ASAI-PT or BRI-PORT only, release
the port using release port location and run the test again.
3. If the error is present for both ASAI-BD and ASAI-PT or BRI-BD and
BRI-PORT, release the board using release board location
and run the test again.
Note: When
Note:
you release a port, you release every port
associated with it. If certain ports still need to be busied
out, use busyout port location to busy them out.
4. Make sure the terminal is connected.
5. Retry the command at 1-minute intervals up to 5 times.
6. If the test continues to abort, escalate the problem.
2000 ABORT Response to the test was not received within the allowed time.
1. If the test aborts repeatedly up to five times, reset the circuit pack and
rerun the test.
2. If the test aborts again, replace the circuit pack.
2012 ABORT Internal system error.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
1756 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 4