Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
● POW-SUP (Power Supply)
● RING-GEN (Analog Ring Generator)
● RMC-ENV (Power/Fan Sensors)
● SER-BUS (Serial Communication Bus)
Table 422: Ring Generator Initialization Test (#117)
Error
Code
1
1000
1001
1003
1115
2012
2100
Test
Result
Ring Generator Query Test (#118)
The Ring Generator Query test requests the active Tone-Clock circuit pack to check the ringing
voltage. The Tone-Clock circuit pack replies with PASS if the ringing voltage is adequate to ring
the analog phones. If not, the active Tone-Clock circuit pack replies with a FAIL.
This test runs on the following maintenance objects:
● AC-POWER
● CABINET (Cabinet Sensors)
Description / Recommendation
ABORT The system is unable to determine the active Tone-Clock circuit pack,
unable to allocated the resources necessary to run the test, or unable
to send a downlink message.
1. Wait for the green LED on the active Tone-Clock to go out.
2. Enter status port-network to determine the active
Tone-Clock circuit pack.
3. Rerun the test. If the test aborts again, see TDM-CLK (TDM Bus
Clock).
2000 ABORT Response from the test was not received within the time allowed.
1. Look for TDM-CLK errors and alarms. Resolve every TDM-CLK
(TDM Bus Clock) problem first.
2. Rerun the test.
PASS The active Tone-Clock has successfully been enabled to monitor the
ringing voltage level.
● CARR-POW (Carrier Power Supply)
● DC-POWER (Single-Carrier Cabinet Environment)
1566 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers