Server Alarms - Avaya Support

Expansion Interface Lightwave Transceiver Looparound Test (#242)
Table 472: Expansion Interface Lightwave Transceiver Looparound Test (#242) 2 of 5
Error
Code
Test
Result
Description / Recommendation
1033 ABORT The test cannot run because the EI circuit pack does not have a fiber link
administered to it and there is not sufficient data to run the test.
1. Enter list fiber-link to verify that there is no fiber link
administered to this circuit pack.
2. If there is no fiber administered to this circuit pack (but should be),
add the correct fiber using add fiber-link.
3. Retry the command.
1139 ABORT The packet bus in the PN where this EI board resides has a major alarm
against it. This test needs to use the alarmed PN’s packet bus.
1. Enter display alarms and display errors and resolve any
PKT-BUS alarms.
2. Retry the command.
1141 ABORT The Packet Interface circuit pack is out of service.
1. See PKT-INT (Packet Interface).
1144 ABORT The PN’s packet bus has a major alarm against it. This test needs to use
the alarmed PN’s packet bus.
1. Enter display alarms and display errors and resolve any
PKT-BUS alarms.
2. Retry the command.
1394 ABORT The EI board is out of service and the test cannot be run. This condition
is due to a change in the EI board’s ability to communicate with the EI or
SNI circuit pack on the other end of the fiber.
1. Run Test #237 and check the Error Log for EXP-INTF Error Type
1281. If Error Type 1281 is present or if Test #237 does not pass, see
repair procedures for Expansion Interface Neighbor Query Test
(#237).
2 of 5
Communication Manager Release 5.0 Issue 4 January 2008 1679