Server Alarms - Avaya Support

MAPD-BD (MAPD Interface Circuit Pack)
Before backing up, be sure to shut down the application running on the circuit pack, following
the procedures in Shutting Down NT on the TN802.
Note: Local
Table 262: Backing up TN802 administration data
Step Description Comments
1. Busyout circuit pack On the S8700 Media Server terminal, enter busyout board
location (the address of the TN802 circuit pack)
2. Backup
administration TN802
to disk
Note:
restore of a complete system from the PCMCIA disk should not require
more than 20 minutes assuming that a replacement MAPD pack is available and
pre-loaded with the IP trunk application software.
Restoring Data from the PCMCIA Disk
Before You Start
At the Windows 2000 desktop, double-click on the IP Trunk
Backup Restore icon.
The IP Trunk Backup/Restore Utility screen appears.
3. Select utility In the IP Trunk Backup/Restore Utility dialog screen, click on
Files > Backup.
The IP Trunk Backup screen appears.
4. Select backup In the IP Trunk Backup screen, click on the Backup button.
5. Wait Backup can take as much as 20 minutes to complete.
6. Release circuit pack On the S8700 Media Server terminal, enter release board
location (the address of the TN802 circuit pack)
1. Shut down the application running on the circuit pack. See Shutting Down NT on the
TN802.
2. Remove the defective IP Trunk circuit pack from the switch (if applicable).
3. Install the replacement IP Trunk circuit pack in the switch (if applicable).
Communication Manager Release 5.0 Issue 4 January 2008 959