Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
● In a CSS configuration, replace the Switch Node Interface circuit pack connected to
the active Expansion Interface circuit pack in the master port network. Use list
fiber-link to determine the Switch Node Interface circuit pack that is connected to
the active Expansion Interface circuit pack in the master port network.
● If the problem persists and any slip errors remain, follow the procedures described in
the troubleshooting section above.
It may take up to one hour to clear the alarm after the problem has been resolved.
i. Noise on the DS1 line can cause transient alarms on synchronization. Therefore, when a
sync problem occurs on Error Types 1, 257, or 513, a WRN alarm is first raised for 15 to 20
minutes before the alarm is upgraded to a MINOR or MAJOR alarm.
Table 343: Synchronization Error Log Entries
Error Type Aux
Data
0 1
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 Any Any Any test synchronization
1 (a) (g) Any WRN
MIN (j) 2
OFF
18 (b) 0 disable sync WRN OFF enable sync
257 (c)(g) Any WRN
MIN (j) 2
OFF
513 (d)(g) Any WRN
2
MAJ (j)
OFF
769 (e) MAJ
WRN 3
OFF
1793 4
0-50 MAJ
WRN
OFF enable sync
2049 (f) 4
0 WRN OFF
2305 (f) 4
0 WRN OFF
1. Run the Short Test Sequence first. If all tests pass, run the Long Test Sequence. Refer to the appropriate
test description and follow the recommended procedures.
2. This Error Type initially raises a Warning alarm. If this Error Type persists and alarms are not
downgraded on this MO due to the value of set options, then, after a period of time, a Minor or Major
alarm is raised.
3. Major alarms on this MO may be downgraded to Warning alarms based on the value used in set
options.
4. It can take up to one hour for these SYNC alarms to clear.
1280 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers