Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on SNI-BD (SNI Circuit Pack) and SNI-PEER (SNI Peer Link).
Table 538: Packet Neighbor Link Test (#767) 1 of 5
Error
Code
Test
Result
Description / Recommendation
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The software timer could not be set before sending the downlink message
necessary to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2302 ABORT Software received incorrect message data from the SNI circuit pack.
1. Retry the command at 1-minute intervals up to 3 times.
2303 ABORT The SNI circuit pack responded that the software test requested is invalid.
1. Retry the command at 1-minute intervals up to 3 times.
2304 ABORT SNI firmware is not able to run the test. For this particular test, the SNI
circuit pack must be able to communicate with its neighbor.
1. Verify that the SNI can communicate with its neighbor by checking the
yellow LED of the SNI to make sure the SNI is in frame, or by running
test board for the SNI and checking test 989 for fiber out-of-frame.
If the results of Test 989 indicate that the fiber is out-of-frame, follow
the recommendation associated with the test failure. If a DS1
converter complex exists on the fiber link, enter display errors
and follow the repair procedures for any DS1C-BD and DS1-FAC
entries.
2. Retry the command at 1-minute intervals up to 3 times.
1834 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 5