Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
TIE-TRK (Analog Tie Trunk)
MO Name In Log Alarm Level Initial Command to Run 1
TIE-TRK MAJ 2
MIN
1. If ATMS testing is enabled, check the error log for ATMS errors 3840 and 3841. If the error log
indicates that measurements exceeded acceptable thresholds, and no other trouble is found with
test trunk, run the ATMS test call with test analog-testcall port location full.
Note:
Note: Many trunk problems are caused by incorrect settings of parameters on the trunk
group administration screen. Settings must be compatible with the local
environment and with parameter settings on the far end. Refer to Administrator
Guide for Avaya Communication Manager, 03-300509. Refer to your Avaya
representative for the correct settings for administrable timers and other
parameters on a country-by-country basis.
The following circuit packs, including every suffix such as TN760D, support analog tie trunks:
Each tie trunk circuit pack occupies a port circuit pack slot and contains 4 port circuits. Each port
circuit supports 1 analog tie trunk used to connect the switch to another PBX across 1- or 2-way
dedicated circuits (see preceding list).
A tie trunk port can also be administered as an access endpoint which is a non-signaling
channel with a voice-grade data bandwidth. Tie trunk maintenance employs up to 6 tests,
depending on the hardware involved, to monitor the operating condition of the trunk and its
1338 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
Full Name of MO
2. A Major alarm on a trunk indicates that alarms on these trunks are not downgraded by set options
and that at least 75 percent of the trunks in this trunk group are alarmed.
This alarm does not apply to TN497.
test port location l Analog Tie Trunk
WRN test port location
Table 358: Analog Tie Trunk Circuit Packs
Code Trunk Type Signaling Leads
TN760 4-wire E&M
TN437 4-wire E&M
TN439 2-wire A&B (2-way circuits only)
TN458 4-wire E&M
TN497 2-wire A&B
TN2140 4-wire E&M