Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 458: Announcement Checksum Test (#209) 2 of 3
Error
Code
Test
Result
Description/ Recommendation
1024 ABORT The test aborted for one of the following reasons:
1. An announcement upload or download is in progress.
2. An announcement upload or download was requested while this test
is running.
3. A record is in progress.
4. A record request comes in when this test is running.
If an announcement upload or download is in progress, the command
status data-module should
show that the announcement data port is connected to a NETCON data
channel, and the "card-in-use" LED for the memory card is on. To
determine the extension of the announcement data module, enter
list data-module.
See Note (a) at the end of the table for Test #205 for more information.
1. Wait until the blocking event is finished, then run this test again. An
upload or download could take up to 45 minutes to complete. A
recording session is finished as soon as the station that was making
the recording is placed on-hook.
2. If the test continues to abort, and a record or upload/download is not
in progress, escalate the problem.
2000 ABORT Response to the test request was not received within the time allowed.
1. Enter display errors. If Error Type 1538 is present in the Error
Log for this board, reset the circuit pack.
2. Retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
1646 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 3