Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on EXP-INTF (Expansion Interface Circuit Pack).
Table 472: Expansion Interface Lightwave Transceiver Looparound Test (#242) 1 of 5
Error
Code
Test
Result
Description / Recommendation
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1015 ABORT The EI circuit pack has not been busied out.
1. Busyout the EI circuit pack with busyout board location
2. Enter test board location long.
1031 ABORT If the EI circuit pack is in a PN and is on the active PNC, and is not part of
a PN-to-PN link, this test cannot be executed. If the lightwave transceiver
looparound is activated, it is impossible to deactivate it.
1. If PNC Duplication is enabled, attempt to make the standby PNC
active with reset pnc interchange.
2. If the PNC Interchange is successful, the Lightwave Transceiver
Looparound test may now be executed on the original EI circuit pack.
1678 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 5