Server Alarms - Avaya Support

● SYNC (Port Network Synchronization)
Table 491: Synchronization Update Test (#417)
Error
Code
None
1000
1115
2500
Test
Result
Description / Recommendation
Digital Port Sanity Test (#565)
Digital Port Sanity Test (#565)
ABORT Internal system error.
System resources required to run this test are not available.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
PASS The Synchronization Maintenance parameters have been successfully
updated. The system should be synchronized. If synchronization
problems still exist, refer to the Error Log to obtain information about
the source of the problem.
The Digital Port Sanity Test verifies that the port circuitry involved in the digital trunk testing on
the Maintenance/Test digital port is functioning properly. This circuitry is common to both
Maintenance/Test digital ports on the Maintenance/Test circuit pack and is only run for port 2.
The test aborts if it is run on port 3.
The test connects the two Maintenance/Test digital ports on the TDM bus so that they talk and
listen to each other. Four self-tests are attempted:
● sending data from port 2 to port 3 in asynchronous mode
● sending data from port 3 to port 2 in asynchronous mode
● sending data from port 2 to port 3 in synchronous mode
● sending data from port 3 to port 2 in synchronous mode
The test passes if all four self-tests are successful. The test stops if any one of the self-tests
fails.
This test aborts if an ISDN test call is in progress on the Maintenance/Test digital port when the
test is requested, or if an ISDN test call is initiated while the test is in progress.
Communication Manager Release 5.0 Issue 4 January 2008 1717