Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)
Table 430: Internal Looparound Test (#135) 1 of 3
Error
Code
Test
Result
Description / Recommendation
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service due
to TDM-BUS errors. A system is considered under heavy traffic when the
Call Processing Occupancy is greater than 50% or when the System
Management and the Call Processing Occupancies together exceed
65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT Received an incoming call on a port of the DS1 circuit pack during the
test.
1. Enter busyout board location to put every trunk on the DS1
circuit pack into the out-of-service state.
2. Retry reset board location at 1-minute intervals up to 5 times.
1588 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 3