Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 492: Digital Port Sanity Test (#565) 3 of 3
Error
Code
100
101
102
103
Test
Result
Description / Recommendation
FAIL Data not sent successfully from port 2 to port 3 in asynchronous mode.
Data not sent successfully from port 3 to port 2 in asynchronous mode.
Data was not sent from port 2 to port 3 successfully in synchronous mode.
Data was not sent from port 3 to port 2 successfully in synchronous mode.
One of the self-tests failed.
1. Reset the circuit pack.
2. Test the port again with test port location (02) long.
3. If the test fails again, replace the circuit pack.
PASS The Maintenance/Test digital port digital trunk testing capability is operating
correctly.
Hook State Inquiry Test (#566)
This test verifies that the Maintenance/Test analog port and the system agree on the on-hook/
off-hook status of the Maintenance/Test analog port. It runs on M/T-ANL (Maintenance/Test
Analog Port) and M/T-DIG (Maintenance/Test Digital Port).
Table 493: Hook State Inquiry Test (#566) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1 ABORT No response was received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continues to abort, replace the circuit pack and repeat the
test.
2100 ABORT System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 3 times.
1720 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
3 of 3
1 of 2