Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 629: Network Region Interconnectivity Test (#1417) 2 of 3
Error
Code
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the problem persists, reset the circuit pack.
3. Rerun the test. If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2100 ABORT Could not locate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals, up to 5 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2801 ABORT No IP address defined.
1. Verify IP interfaces translations and retest.
2802 ABORT Different IP address pinged than was allocated for the test.
1. Retry the command at 1-minute intervals up to 3 times.
2807 ABORT The board is administered but not enabled on the
change ipserver-interfaces screen.
1003 FAIL Ping to the destination failed due to on-board problems of the source of
the ping. The source of the ping can be a C-LAN board or a IPMEDPRO
board for this error to occur.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Look for problems associated with IPMEDPRO or C-LAN boards in
this region.
7
89
1007
Test
Result
Description / Recommendation
FAIL Ping to the destination failed due to the destination being down.
1. Verify that at least one destination reachable through the network
regions being tested is up. Ping this destination (ping ip-address
xxx.xxx.xxx.xxx).
2018 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 3