Server Alarms - Avaya Support

Primary Signaling Link Hardware Check (#636)
Primary Signaling Link Hardware Check (#636)
This test runs on ATM-SGRP (ATM Signaling Group) and ISDN-SGR (ISDN-PRI Signaling
Group).
For ATM-SGRP, the ATM-SGRP Signaling Group D-channel port depends on the health of the
TN230X interface circuit pack on which it resides. This test fails if there are problems with either
the ATM-DCH (D-channel port) MO or the TN230X circuit pack. Investigate the ATM TN230X
circuit pack ATM-TRK (Circuit Emulation Service Circuit Pack) anytime there are problems with
the ATM D-channel port ATM-DCH (ATM D-Channel Port).
For ISDN-SGR, the ISDN-PRI Signaling Group D-channel port depends on the health of the
TN464 UDS1 Interface circuit pack or DS1 Interface Media Module on which it resides. This test
will fail if there are problems with either the ISDN-PRI Primary D-channel port or the UDS1
circuit pack or DS1 Media Module. If there are problems with the ISDN-PLK (ISDN-PRI
Signaling Link Port), also investigate UDS1-BD (UDS1 Interface Circuit Pack) or MG-DS1 (DS1
Interface Media Module).
Table 521: Primary Signaling Link Hardware Check (#636) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1700 ABORT Rollabout video abort. The PRI terminal adapter associated with the
primary D-channel port is detached from the circuit pack or media
module. This is a normal abort when the rollabout video feature is
enabled. To complete test on this port, either:
1. Re-attach the disconnected PRI terminal adapter, or
2. Enter change ds1 location to disable rollabout video on the
board, and set the Alarm when PRI Endpoint Detached field to y.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1779